Author Topic: Bore Deburring  (Read 653 times)

mcr1010

  • Hatchling
  • *
  • Posts: 1
Bore Deburring
« on: May 23, 2018, 12:46:58 PM »
I did not see this tip for removing very small burrs not visible to the naked eye, from the edges of lands in the bore, so thought I would pass it along. 
For the 9mm you will need a 5/16 dia. wood dowel about 8-12 inches long and SS wire scouring pad.   Cut a few coils off the pad and wrap on the dowel.  Push or drive the dowel thru the bore in both directions.  The  SS coils are not hard enough to wear the bore lands, but will take off the burrs and keep the bore from fouling as quickly.  Also, this method is good for cleaning out heavy fouling. 
This tip was on the Kel Tec forum years ago by an old time gunsmith......Jack  RIP Jack.
IMG_7179.JPGBore Deburring
* IMG_7179.JPG (87.05 kB . 649x404 - viewed 235 times)  IMG_7180.JPGBore Deburring
* IMG_7180.JPG (80.89 kB . 663x438 - viewed 237 times)

 

Diamondback Firearms

__________


Diamondback Firearms

__________


Galloway Precision

__________