Author Topic: DB9 striker spring spacer  (Read 372 times)

mitch9mm

  • Hatchling
  • *
  • Posts: 22
DB9 striker spring spacer
« on: December 04, 2018, 10:11:51 AM »
I replaced the factory spring with the Galloway spring. With the Galloway spring in place there wasn’t enough give in the spring to replace the spacer that is used with the factory spring.  I reassembled the gun without the spacer and have shot approximately 75 rounds with no issues. Anyone else experience this?
Thanks.

Bassdeer

  • Hatchling
  • *
  • Posts: 14
Re: DB9 striker spring spacer
« Reply #1 on: December 14, 2018, 04:34:25 PM »
Are you talking about the two little cups that go on the end of the spring?

mitch9mm

  • Hatchling
  • *
  • Posts: 22
Re: DB9 striker spring spacer
« Reply #2 on: December 14, 2018, 09:40:23 PM »
I think you are talking about the 2 half moon clips that actually retain the spring onto the striker.
But no the spacer I’m referring to is located at the other end of the spring which would be toward the rear of the slide.

Bassdeer

  • Hatchling
  • *
  • Posts: 14
Re: DB9 striker spring spacer
« Reply #3 on: December 15, 2018, 09:06:58 AM »
I see, I just pick a DB9 up and change it out with the same spring from Galloway and got it on there, wasn't easy but I got it on. As long as it works go with it.

 

Galloway Precision

__________


Diamondback Firearms

__________


Diamondback Firearms

__________